PUMP & GEARBOX - V-TUF SUPER SERIES XHDM400SSGB 1" HOLLOW SHAFT - 15L/MIN @ 200BAR 1450RPM, - XHDM400SS-GBKIT
Key Features
- 15 L/MIN AT 200 BAR, ASSEMBLED – XHDM400SS pump pre-fitted with XHDG500SS gearbox, ready to install
- 1" FEMALE HOLLOW SHAFT – built for 7.5HP engines to run at full rated pressure
- NICKEL-PLATED PUMP HEAD – larger oil bath and extra cooling fins for quieter, cooler running
- DIRECT ALTERNATIVE – to Interpump WS201, V-TUF VT301, and AR RK 15.20H pumps
- GENUINE V-TUF KIT – used on the GB080 pressure washer, supplied from our Lincoln warehouse
Description
Pump & Gearbox - V-TUF Super Series XHDM400SSGB, 1" Hollow Shaft, 15 L/min @ 200 Bar 1450 RPM (XHDM400SS-GBKIT) is the XHDM400SS solid 24mm shaft pump pre-assembled with the XHDG500SS gearbox, delivering 15 L/min at 200 Bar at 1450 RPM with a 1" female hollow shaft input. Features toughened nickel-plated pump heads, a larger oil bath, extra cooling fins, and quieter running. Used on the GB080 pressure washer.
For: Engine-driven pressure washer installations requiring a 1" hollow shaft pump and gearbox at 200 Bar. 7.5HP required to run at full pressure. Suitable replacement for Interpump WS201, V-TUF VT301, AR RK 15.20H, and V-TUF XHDM400.
Key specifications:
- Flow: 15 L/min
- Pressure: 200 Bar (3000 PSI)
- Speed: 1450 RPM
- Input: 1" female hollow shaft
- Ports: 2x inlet 1/2" F BSP (one blanked), 2x outlet 3/8" F BSP (one supplied with blanking plug)
What's included:
- 1x XHDM400SS-GBKIT assembled pump and gearbox unit (unloader valve not included)
Important: Most mains water supplies cannot cope with 15 L/min — running on suction from a water butt or tank is advised if unsure. This pump is NOT supplied with an unloader valve and MUST be fitted with one before operation. Service kits: unloader and inlet filter kit C0.194KIT2, valve kit VTPKIT2, water seals VTPKIT28, pistons VTPKIT120571, oil PL500.
Safety — before powering the system:
- The unloader valve MUST be set to minimum pressure.
- The bypass port MUST be open.
- Set the unloader to the required pressure, which MUST be less than both the unloader's maximum rated pressure and your equipment's maximum pressure (do not exceed 200 Bar / 3000 PSI).
- Set the locking nuts so the running pressure and lock line pressure cannot be exceeded.
Caution: this is high pressure equipment. Failing to follow the above safety and set-up rules can cause serious equipment damage and injury — caps and joints can be blown clean out of their threads, creating dangerous projectiles. Call 01522 787978 if you need assistance.
Support: See the Pump Spare Parts page, or call our Lincoln service team on 01522 787978.
Genuine V-TUF part, supplied from our Lincoln warehouse.
Specifications
- Working Pressure (Bar)
- 200
- Horsepower (HP)
- 7.5
- Flow Rate (L/min)
- 15.0
- Shaft size
- 1" hollow (input)
- Speed (RPM)
- 1450